Slide the key into the lock and turn to open the trunk. The lock is centered here underneath the v-shaped flag emblem. Dead fob c6 corvette license#To find it, look underneath the small overhang just above the license plate. Dead fob c6 corvette how to#Also: It has been reported that having a cell phone on your person, during the long method, may cause interference and not allow you to get the correct response for Step #9. How to open a C6 with a dead battery There is a lock on the rear of the Corvette, though it is tucked out of sight.Also: This can be a long time “on battery”, it may be a good idea to hook a battery tender up to the car during programming to insure that you don’t discharge the battery to where the programming fails or the car won’t start.All FOB programming must be done by the dealer. Also: European Spec cars cannot do the short or long procedure.Also: Canadian Spec cars can do the short programming procedure but must have the dealer perform the long programming procedure.(The steps and numbering listed here are for the pdf, not for the above.) Here is what it says: Dead fob c6 corvette pdf#There are also some caveats at the top of the pdf which explains these procedures may not work in every country. NOTE: There is this pdf which goes over the procedures as well. The steps for the first procedure can be found here as well. Test all buttons on the fobs to make sure they work, then take all fobs away from the car and, one by one, try using each to start the car.When you have no more Fobs to program, push the bottom half of the Start button to end the programming session. The car will take a maximum of four fobs. After 3 or four seconds the DIC will beep and say “Ready for Fob #2”.Put the first Fob in the glovebox slot with the buttons facing to the right (passenger) side and the keyring end facing outwards. After this third ten minute period is over, DIC will say “Ready for Fob #1” Regardless of the number on the Fob, the FIRST Fob that is put in the glovebox slot will be recognized as Fob #1.DIC will again start counting down the ten minutes. After the second 10 minute countdown, DIC will again say “Off/Acc to learn”.After the first 10 minute countdown, DIC will again say “Off/Acc to learn”.You may close the trunk and car door while waiting for the ten minute countdowns. DIC will say to wait 10 minutes and will start counting down the minutes. With step 7, all previous fobs will be erased. DIC will now beep and light up and say “Off/Acc to learn” If you decide at this point NOT to do the programming now, push the TOP half of the Start button and the car will return to normal.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |